Laboratory hotplate PL-01

Design features

The heating surface made of duralumin and the PID controller provide high accuracy and uniformity of the temperature of the plate surface heating.

The body of the plate is made of corrosion-resistant steel.

The design of the plate protects the body, electronic components and controls from spilling liquids onto the heating surface.

Operating features

Two modes of operation of the plate allow maintaining the temperature of the heating surface for a specified time or without time limit. The display shows both current and st heating parameters.

During the operation of the plate the user can change the time and/or heating temperature.

When the plate is turned off the settings of the last operating mode are saved.

For safety reasons the plate has a hot surface indicator that works even when the mains switch is turned off.

Specifications

Operating temperature range of the heating surface: from 40 to 400 ��.

Instability of maintaining the set temperature: 5 ﾰC.

Insulation resistance of mains supply circuits: no less than 10 M?.

Maximum time to complete the heat treatment step: 599 minutes.

The plate is powered from a 1-phase alternating current network with a voltage of (230ﾱ22) V and a frequency of (50ﾱ1) Hz.

Power consumption of the plate: no more than 1500 W.

Dimensions: heating surface: 284´220mm;

the plate: 290´260´130 mm.

Weight: no more than 4,7 kg.

Average service life: at least 3 years.

Optional extra

The plate can be equipped with a sand bath tray.

The sand bath tray is removable. The bottom of the sand bath tray is made of duralumin.

Specifications of the sand bath tray

Dimensions: 300�235�65 mm.

Internal dimensions: 284�220�50 mm.

Tray weight: 1,1 kg.

Mass of quartz sand: (3.0ﾱ0.1) kg.